New Holland T8010 Manual page 762

Optional MegaFlow PFC Piston Pump
The axial piston pump has a variable flow output and can operate at variable pressures.The pump matches the
hydraulic power output to the actual load requirements to ensure maximum efficiency and the minimum use of fuel.
The pump inlet is charged to prevent cavitation. The pump output flow is supplied directly to the remote auxiliary
manifold. The manifold is equipped with internal plugs to separate the MegaFlow supply flow, signal line pressure
and signal line pilot relief from the standard PFC piston pump circuit. The MegaFlow pump supplies only the third,
fourth or fifth remote sections. The two PFC pump hydraulic circuits operate independently.
The maximum pump flow rate (through one remote section) at rated speed 2667 RPM (2000 engine speed) is 117
L/min (31 GPM).
1. CHARGE/LUBRICATION PUMP OUTLET (REAR SECTION)
2. REGULATED CIRCUIT PUMP OUTLET (FRONT SECTION)
3. PFC PISTON PUMP
Section 35 - Hydraulic Systems, 3PT - Chapter 2
1
6
35-2-5
4
4. DUAL GEAR PUMP/ REGULATED SYSTEM FILTER HOUSING
5. MAIN FILTER ASSEMBLY
6. MEGAFLOW PFC PISTON PUMP
2
3
5
RH02K092