New Holland T8010 Manual page 953

Hide thumbs Also See for T8010:

Table of Contents

Use a Torx screwdriver to remove the upper and

lower steering column covers.

Remove the horn button. Remove the steering wheel

retaining nut and flat washer. Mark the position of the

steering wheel on the column for reassembly.

Remove the steering wheel with a swift, upward pull.

NOTE: If the steering wheel cannot be removed by

the method above, use a steering wheel puller.

Section 41 - Steering - Chapter 1

Remove the retaining screw from the steering

column upper control housing.

R e m o ve t h e t w o s t e e r i n g c o l u m n e l e c t r i c a l

connectors (1). Remove the cable clip with pin (2)

from the steering column tilt mechanism cable.

Loosen the cable lock nuts (3) from the anchor

bracket, and move the cable aside.

Loosen the socket head cap screw for the turn signal

switch clamp and remove the lower control housing.

Chapters

Table of Contents

T8020 T8030 T8040