New Holland T8010 Manual page 292

STEP 142
Install the lube management ring.
STEP 143
1
Install the final three piston return Belleville washers
as shown.
NOTE: Make sure the concave side of first washer
(1) is facing downward.
STEP 144
Install the needle thrust bearing and the two bearing
thrust washers. The needle bearing must be between
the two bearing thrust washers.
Section 21 - Transmission, Drivelines - Chapter 6
RD05M017
RD05M016
T95778
21-6-39
STEP 145
Install the snap ring onto the shaft.
STEP 146
Install the snap ring and Belleville washers as
follows:
1. Install the compression sleeve with the notch
CAS1903-3 over the shaft and snap ring (see
Special Tools in this section).
2. Position the opening in the compression sleeve
over the ends of the snap ring.
3. Compress Belleville washers with a hydraulic
press.
4. Install the snap ring in the groove.
T95777
A10939