New Holland T8010 Manual page 497

Pinion Disassembly
STEP 25
Hold end yoke or flange with tool similar to the one
shown, and remove nut and washer. Discard nut as
new one must be used at reassembly. (1-5/16 inch
socket).
STEP 26
Remove end yoke. If yoke or flange shows wear in
the seal contract area, if should be replaced
Section 25 - Four-Wheel Drive Front Axle - Chapter 8
RR98K021
T98483
STEP 27
If a new yoke dust shield is required, use CAS-2596
or 3800011108 Yoke Dust Shield Installer with FNH
299077 or 380001112 Handle
STEP 28
Remove the pinion by tapping with a rawhide
hammer. Support the pinion to prevent it from falling
and being damaged.
25-8-8
RR98K012
RR98K019