New Holland T8010 Manual page 198

STEP 117
Install the two bearing thrust washers and the needle
thrust bearing. The needle thrust bearing must be
between the two bearing thrust washers.
STEP 118
If the transmission has the creep option, install the
snap ring against the bearing thrust washer.
STEP 119
Install the creeper speed gear (if equipped). The
longer hub of the gear must face down.
Section 21 - Transmission, Drivelines - Chapter 4
A11538
T95361
T95362
21-4-37
STEP 120
1
1. LONGER HUB
Press the creeper speed gear into position.
STEP 121
Install the bearing cone on the shaft. The larger OD
end of the bearing cone must face down. Press the
bearing on the inner race to properly seat the bearing
on the shaft.
STEP 122
Turn the shaft over and install the first piston return
Belleville washer. The concave side of the washer
must be facing down.
T95363
A11516
RD05M004