New Holland T8010 Manual page 176

Hide thumbs Also See for T8010:

Table of Contents

Install countershaft components as follows:

1. Install the plug (2) and press in place as shown;

3 mm (0.118 in.) (A) beyond the face of the shaft.

2. Install the dowel pin (3) and press in flush as

Section 21 - Transmission, Drivelines - Chapter 4

1. 1ST-2ND DRIVERGEAR

2. REAR BEARING CONE

3. 3RD STEEL BALL

4. 2ND STEEL BALL

Install steel balls as follows:

1. Apply petroleum jelly to the first steel ball (6) and

install ball into hole in shaft for (1st-3rd-5th)

driven gear (7).

2. Heat the (1st-3rd-5th) speed driven gear in a

bearing oven for 3 to 4 hours at a temperature of

350 to 370° F (177 to 187° C).

WARNING: Always wear heat protective

gloves to prevent burning your hands when

handling heated parts.

NOTE: Do not heat the gear beyond a temperature

of 375° F(190° C).

3. Install the gear over the shaft, engaging the ball

and seat against the shaft shoulder.

4. Apply petroleum jelly to the second steel ball (4)

and install into the shaft hole for (3rd-4th) speed

driver gear.

5. 3RD-4TH DRIVER GEAR

6. 1ST STEEL BALL

7. 1ST-3RD-5TH DRIVEN

Chapters

Table of Contents

T8020 T8030 T8040