STEP 14
2
Remove the bolt, washer, spacer and nut (1).
Remove pin (2) of the hitch lift cylinder (both sides).
STEP 15
Remove the bolt, locking flag plate, and holding pin
and free the lower end of the hitch lift cylinder.
Remove the cylinder. Repeat Steps 17 and 18 for
opposite side.
IMPORTANT: Note the position of the plate to the
slot for correct assembly.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
1
RD03F019
RD03g003
36-28
35-11-10
STEP 16
Support the nut that attaches the position locator
bracket to the tie rod.
NOTE: Right side nut (shown) should be held in
place while nut on left side is removed.
STEP 17
Remove the position sensor bracket.
NOTE: This step only needs to be performed if the
tires prevent removal of the tie rod assembly (shown
in the lower right corner of the previous drawing).
36-9
36-5