STEP 110
Place the large aluminum pilot tool onto the bearing
cup with the small pilot diameter facing up.
STEP 111
1
Align the flat bar with the small pilot diameter (1) and
fasten to the adapters using the bolts provided.
STEP 112
Use a hoist (or other suitable means) and lift the hub
with mounted alignment tools and align with the
spindle.
Section 25 - Four-Wheel Drive Front Axle - Chapter 10
RD05D241
RD05D242
RD04D243
25-10-32
STEP 113
Push the hub (by hand) onto the spindle until contact
with the seal is made. The threaded rod should be
exposed.
STEP 114
Install a washer and nut onto the threaded rod.
STEP 115
Tighten until a noticeable increase in torque is
required to turn the nut. At this point the seal should
be fully seated.
RD04D245
RD04D246
RD04D247