New Holland T8010 Manual page 282

Hide thumbs Also See for T8010:

Table of Contents

Install the snap ring for the piston return Belleville

washers. This ring goes into the second groove down

on the shaft.

Install the eight piston return Belleville springs. The

concave side of the first spring must be facing up, the

second facing down. Continue to alternate.

Install the lube management ring.

Section 21 - Transmission, Drivelines - Chapter 6

Install the final Belleville spring concave side down.

Install the retaining ring onto the shaft along with the

Belleville washer compression sleeve. Use tool

Install the compression sleeve with the notch

CAS1903-3 over the shaft. Use a hydraulic press to

press the compression sleeves down. The snap ring

will slip into position in the groove.

Chapters

Table of Contents

T8020 T8030 T8040