STEP 129
Remove the caged needle bearing.
STEP 130
Remove the bearing spacer.
STEP 131
Remove the caged needle bearing.
Section 21 - Transmission, Drivelines - Chapter 6
T95771
T95772
T95773
21-6-35
STEP 132
Remove the two bearing thrust washers and the
needle thrust bearing.
STEP 133
Remove the snap ring as follows:
1. Install compression sleeve with the notch
CAS1903-3 over the shaft and on top of the
piston return Belleville washers.
2. Position the opening in the compression sleeve
over the ends of the snap ring.
3. Compress the Belleville washers with a press
and remove the snap ring.
T95774
A10939