New Holland T8010 Manual page 340

Valve Removal
NOTE: Before removing
thoroughly clean the valve body and the area on the
transmission housing adjacent to the valve body to
eliminate any contamination.
STEP 1
2
1
1. SPEED TRANSMISSION CONTROL VALVE
2. ODD-EVEN TRANSMISSION CONTROL VALVE
3. RANGE TRANSMISSION CONTROL VALVE
To gain access to the speed transmission control
valve, remove the fuel tank. See the Fuel Tank
section of this manual for procedure. For access to
the odd-even and range transmission control valves,
raise or remove the cab. See the Cab Raise/Removal
and Installation Section of this Repair Manual for
procedure.
STEP 2
1
Remove speed transmission control valve as follows:
1. Tag the wire harness connectors to the solenoids
and pressure sensor (1) and disconnect.
2. Remove the valve supply tube (2).
Section 21 - Transmission, Drivelines - Chapter 7
any components,
3
RI02E0887
2
RD02E276
21-7-11
3. Remove the valve retaining bolts, valve body,
and gasket. Discard the gasket.
STEP 3
2
Remove the odd-even transmission control valve as
follows:
1. Tag and disconnect the park lock and if
e q u i p p e d , t h e F W D t u b e s ( 1 ) . Ta g a n d
disconnect the regulated pressure tubes (2).
2. Tag and disconnect the solenoid wires (3).
3. Remove the mounting bolts (4) and remove the
valve and gasket. Discard the gasket.
STEP 4
1
3
Remove the range transmission control valve as
follows:
1. Tag and remove the regulated supply tube (1).
2. Tag and disconnect the wire harness from the
solenoid (2).
3. Remove the mounting bolts (3), valve body, and
gasket. Discard the gasket.
3
1
4
RD02E275
2
RD02E274