New Holland T8010 Manual page 200

Hide thumbs Also See for T8010:

Table of Contents

Install the reaction plate, fr iction plates, and

separator plates as follows:

1. Install the reaction plate (thicker separator plate).

2. Install the seven new friction plates and six

separator plates, alternating the plates.

Install the backing plate. The flat side of the plate

must face down.

Install the snap ring.

Section 21 - Transmission, Drivelines - Chapter 4

Install the two bearing thrust washers and the needle

thrust bearing. The needle thrust bearing must be

between the two thrust washers.

Install a new seal ring on the (1st-3rd-5th speed)

drive gear. Align the friction plate teeth. Install the

gear over the shaft. The splined hub of the gear

must be facing down.

Chapters

Table of Contents

T8020 T8030 T8040