New Holland T8010 Manual page 494

Hide thumbs Also See for T8010:

Table of Contents

To remove the ring gear from the differential gear

housing half, place shop towels over vise jaws and

secure the assembly in the vise. Do not nick or

otherwise damage the ring gear teeth. Remove ring

gear screws and discard them. New ring gear screws

will be installed during reassembly. (13/16 inch

WARNING: Gear teeth may have sharp

edges. When handling gear, use care to

avoid personal injury.

After removing screws, tap the ring gear with a

rawhide or plastic hammer to separate the gear from

the housing half.

Section 25 - Four-Wheel Drive Front Axle - Chapter 8

Mark the housing halves for reassembly. Also, mark

the end of the cross shaft that is nearest the housing

mark for reassembly.

Place shop towels over and between the vise jaws. This

will prevent possible damage to the axle shaft. Place

one of the axle shafts into the vise with the spline end

extending approximately 76.2 mm (3 inches) above the

vise. This will be used as a holding device for

disassembly and assembly of the differential housing.

Chapters

Table of Contents

T8020 T8030 T8040