New Holland T8010 Manual page 820

Load Check Inspection On The Tractor
IMPORTANT: Always fully lower and disconnect any
implements from the remote hydraulic couplers
before doing service work on the remote valve
sections.
STEP 1
See the Remote Hydraulic System How it Works and
Troubleshooting Section in this Service Manual
before star ting remote valve service. Once it is
determined that repair or replacement is necessary,
follow the procedures in this section.
STEP 2
3
1
2
1. VALVE SECTION NO. 1
2. VALVE SECTION NO. 2
3. VALVE SECTION NO. 3
The remote valves are located at the rear of the
tractor. Remove the rear cover to access the valves.
Thoroughly clean the remote valves and surrounding
area before performing any service work.
Section 35 - Hydraulic Systems, 3PT - Chapter 4
REMOTE VALVE AND COUPLER SERVICE
5
4
RI02D103
4. VALVE SECTION NO. 4
5. VALVE SECTION NO. 5
STEP 3
Use a 1-inch wrench to slowly loosen the load check
cap to relieve any trapped pressure.
STEP 4
Remove the load check valve. Remove the plunger
from the bore. Check for wear or damage. The
plunger must move freely within the bore.
35-4-3
RI02D103
RD98E128