New Holland T8010 Manual page 168

Countershaft, Input Shaft, And Output Shaft Removal
For Transmissions With Creep Option
STEP 5
Remove housing as follows:
1. Connect a chain to the rear of the speed housing
(shown with cab mounting bracket attached).
2. Use a suitable hoist to remove the housing from
the engine stand.
3. Raise the housing up enough to put the support
blocks in position under the bearing support
cover as shown above.
4. Slowly lower the transmission housing until the
bearing suppor t cover is fully seated on the
support blocks.
NOTE: Be sure the blocks are in the correct position
on the support cover.
5. Reach under the housing and remove the two
remaining support cover retaining bolts that were
tightened only finger tight.
Section 21 - Transmission, Drivelines - Chapter 4
18-8
21-4-7
STEP 6
Slowly raise the transmission housing leaving the
bearing support cover and three shaft assemblies on
the support blocks.
STEP 7
Remove the mounting bolts from the three bearing
cages. Remove the bearing cages and shims.
NOTE: Keep the shims together with the bearing
cage as the cages are removed.
18-11
18-14
18-2