New Holland T8010 Manual page 952

Bolt for Steering Hand Pump Bracket and Isolator ......................................................... 32 to 36 Nm (24 to 27 lb. ft.)
Lock Nut for Steering Column Base ............................................................................... 29 to 32 Nm (22 to 24 lb. ft.)
Nut for Steering Wheel ................................................................................................... 45 to 54 Nm (33 to 40 lb. ft.)
STEP 1
Park the tractor on a hard level surface. Put the
transmission shift lever in PARK. Turn off the engine
and remove the key. Place blocks in front of and
behind the rear wheels.
STEP 2
Remove the two screws (1) from the lower console
panel. Leave the circular heater duct outlets in the
panel. Disconnect the electrical plugs from the
ignition and light switch and remove the panel.
Section 41 - Steering - Chapter 1
SPECIAL TORQUES
STEERING COLUMN REMOVAL
1
1
RD02C075
41-1-3
STEP 3
Remove all circular heater duct outlets from the
upper console panel. Remove the two retaining
screws (1) on each side of the panel. Disconnect the
electrical plugs from the switches and upper indicator
lights. Pull up on the cab floor mat on both sides of
the upper console panel and remove the panel.
STEP 4
Remove the heat duct retaining screw on the left and
right heat ducts. Pull up on the cab floor mat and
remove the left console heat duct. Move the right
heat duct to the right. Removal is not necessary.
1
1
RD02C083
RD02C085