New Holland T8010 Manual page 627

Hide thumbs Also See for T8010:

Table of Contents

Install a lifting strap at the axle balance point. Install a

bolt (1) on each side of the axle, this will prevent the

lifting strap from possibly sliding off. Put tension on

the lift strap. Remove the remaining bolts and remove

NOTE: It will be necessary to break loose the axle

flange sealant by hitting the axle end with a soft faced

planetary, the four gear will be similar.

Remove the ring gear from the axle housing.

Section 27 - Rear Axle - Chapter 1

Remove the retaining ring from the axle shaft.

Use a sling and hoist to remove the planetar y

assembly from the axle.

Remove the sun gear from the brake discs. Clean

and inspect for heavy wear or damage. Replace if

NOTE: If the sun gear is replaced, new planet gears

must also be installed.

Chapters

Table of Contents

T8020 T8030 T8040