New Holland T8010 Manual page 222

Hide thumbs Also See for T8010:

Table of Contents

Install the snap ring.

Install the two bearing thrust washers and the needle

thrust bearing.

NOTE: The needle thrust bearing must be between

the two bearing thrust washers.

Section 21 - Transmission, Drivelines - Chapter 4

Install the 3rd-4th speed driven gear as follows:

1. Install a new seal ring on the (3rd - 4th speed)

driven gear.

2. Align the friction plate teeth. Install the gear into

the clutch pack. The splined hub of the gear

must be facing down.

3. Slight oscillation of the gear will help with the

installation.

4. The splined hub of the gear must engage all the

friction plates.

Install the caged needle bearing.

Chapters

Table of Contents

T8020 T8030 T8040