New Holland T8010 Manual page 378

Hide thumbs Also See for T8010:

Table of Contents

Install the short spacers into the housing so the

smaller diameter ends face the long shaft.

Install the two short pinion shafts (small end first) into

the housing bores, through the short spacers and

into the hole in the long spacer and long pinion shaft.

Keep the locking bolt hole of the short shaft aligned

with the bolt hole in the housing.

Install the short pinion shaft locking bolts through the

housing into the shafts.

Section 21 - Transmission, Drivelines - Chapter 8

Install the differential lock piston in the housing.

Install the six dowel pins into the housing.

Install the locking side gear into the housing so that

the teeth mesh with the pinion gears.

Chapters

Table of Contents

T8020 T8030 T8040