New Holland T8010 Manual page 713

Hide thumbs Also See for T8010:

Table of Contents

Install the output shaft cover. DO NOT apply Loctite®

515 at this time.

Install the mounting bolts and torque to 95 Nm (70 lb. ft.).

DO NOT install the seal at this time, the following rolling

torque measurements are taken without the seal.

Install the output shaft (1).

Place a socket over the end of the output shaft

and rotate the shaft several revolutions in both

directions to seat the bearing.

Check the rolling torque using a inch-pound

torque wrench.

The required rolling torque range is 2-18 lb. in. If

the torque is too low, disassemble and add

shim(s) to the bearing cage. If torque is too high,

disassemble and remove shim(s) from the

bearing cage.

After adding or removing shims, recheck rolling

When the rolling torque is to specification,

remove the PTO output shaft cover.

To continue the assembly, see Reversible PTO

NOTE: The proper method for measuring the rolling

torque is to apply a continuous force on the torque

wrench and maintain a slow, constant rotation, then

average the torque wrench readings.

Section 31 - PTO - Chapter 2

Chapters

Table of Contents

T8020 T8030 T8040