New Holland T8010 Manual page 31

WARNING: Always wear heat protective
!
gloves to prevent burning your hands when
handling heated parts.
WARNING: Lower all attachments to the
ground or use stands to safely support the
!
attachments before you do any maintenance
or service.
WARNING: Hydraulic oil or diesel fuel
leaking under pressure can penetrate the
skin and cause infection or other injury.
To Prevent Personal Injury:
Relieve all pressure, before disconnecting
fluid lines. Before applying pressure, make
!
s u r e a l l c o n n e c t i o n s a r e t i g h t a n d
components are in good condition.
Never use your hand to check for suspected
leaks under pressure.
Use a piece of cardboard or wood for this
purpose. If injured by leaking fluid, see your
doctor immediately.
WARNING: When removing hardened pins
such as a pivot pin, or a hardened shaft, use
!
a soft head (brass or bronze) hammer or use
a driver made from brass or bronze and a
steel head hammer.
WARNING: When using a hammer to
remove and install pivot pins or separate
parts using compressed air or using a
!
grinder, wear eye protection that completely
encloses the eyes (approved goggles or
other approved eye protectors).
Section 00 - General Information - Chapter 2
SM121A
M496
SM171A
M497
M498
00-2-4
WARNING: Use suitable floor (service)
jacks or chain hoist to raise wheels or tracks
!
off the floor. Always block machine in placed
with suitable safety stands.
WARNING: When servicing or repairing the
machine. Keep the shop floor and operator's
compartment and steps free of oil, water,
!
grease, tools, etc. Use an oil absorbing
material and or shop cloths as required. Use
safe practices at all times.
WARNING: Some components of this
machine are very heavy. Use suitable lifting
!
equipment or additional help as instructed in
the Repair Manual.
WARNING: Engine exhaust fumes can
cause death. If it is necessary to start the
engine in a closed place, remove the exhaust
!
fumes from the area with an exhaust pipe
extension. Open the door and get outside air
into the area.
WARNING: When the battery electrolyte is
frozen, the battery can explode if (1), you try
to charge the battery, or (2), you try to jump
start and run the engine. To prevent the
!
battery electrolyte from freezing, try to keep
the battery at full charge. If you do not follow
these instructions, you or others in the area
can be injured.
WARNING: Batteries contain acid and
explosive gas. Explosions can result from
sparks, flames or wrong cable connections.
!
To connect the jumper cables correctly to the
battery of this machine see the Operator's
Manual. Failure to follow these instructions
can cause serious injury or death.
M499
M500
M501
M502
M503
M504