Assembly
NOTE: Disassembly of range valve shown. Other
valves are similar.
NOTE: Only the speed control valve is equipped with
a pressure sensor. See Figure 1 - Transmission
Control Valve with Four Solenoids for pressure
sensor location.
STEP 9
Install new O-rings on the solenoid/ Install the
so le no id i nto th e va lve bod y. Re pea t fo r th e
remaining solenoids. Install the cover plate and
retaining bolts. Tighten the bolts to a torque of 6 to 8
Nm (4 to 6 lb. ft.).
Section 21 - Transmission, Drivelines - Chapter 7
RD02E223
21-7-13
STEP 10
Install new O-rings on the car tridge. Install the
cartridge into the valve body.
Tighten to a torque of 19 to 25 Nm (14 to 18 lb. ft.).
Install new O-rings on the coil and install the coil onto
the cartridge. Tighten the retaining nut to a torque of
6 to 8 Nm (4 to 6 lb. ft.).
Install a new O-ring on the plug. Install the plug to a
torque of 34 to 54 Nm (25 to 40 lb. ft.).
RD02E222