New Holland T8010 Manual page 964

Hide thumbs Also See for T8010:

Table of Contents

Template Name: OML_2_col

Template Date: 2001_03_06

NOTE: The toe in setting must be done on a clean, level surface.

NOTE: See the special tool layout drawings at the end of this section to fabricate the required spacer tubes and

straightedge before starting wheel setting procedure.

Install appropriate lift straps in the weight package

(if equipped). Remove the weight package retaining

Carefully remove the weight package. Adjust the air

pressure in both front tires so that they are equal.

Remove the grease fitting from the upper linkage

pin. Place a circular ring or other suitable device

over an M10 x 60 - 1.0 bolt. (If metric bolt is not

available, a 3/8 in. - 24 x 2.5 in. bolt may be

substituted.) Attach a length of string and a plum

bob to the ring. Allow the plum bob to swing freely in

front of the drag link.

Section 41 - Steering - Chapter 2

WHEEL TOE IN SETTING

Chapters

Table of Contents

T8020 T8030 T8040