New Holland T8010 Manual page 251

STEP 18
1
1
1
2
Tighten the bolts to the following torques:
M16 x 60mm.......... 232 to 262 Nm (171 to 193 lb. ft.)
M16 x 80mm.......... 220 to 250 Nm (162 to 184 lb. ft.)
M16 x 110mm........ 220 to 250 Nm (162 to 184 lb. ft.)
IMPORTANT: Failure to correctly tighten bolts could
lead to failure of the bolts and housing.
STEP 19
Remove all foreign material from the cover and cover
mounting flange. Apply a bead of Loctite Gasket
Eliminator 515 down the center of the flange and
around each bolt hole. Install the cover and seven
bolts. Tighten all bolts to a torque of 54 to 61 Nm (40
to 45 lb. ft.).
Section 21 - Transmission, Drivelines - Chapter 5
3
1
2
BOLTSEQ5
T95616
21-5-8
STEP 20
Install tube removed from the remote valve.
STEP 21
Move the wire harness (1) and controllers back in
position. Connect the remote auxiliary controller (2)
to the wire harness.
STEP 22
1
Install the two steering priority lines (1) and the two
lines (2) for the trailer brake valve (if equipped).
RD02C188
1
2
RD02C197
2
2
RD02C186