New Holland T8010 Manual page 349

STEP 28
Install the solenoid cartridge and tighten to a torque
to 12 to 18 Nm (9 to 13 lb. ft.).
STEP 29
Instal new O-rings on both ends of coil. Install over
the solenoid cartridge. Make sure the connector on
the coil is facing outward.
STEP 30
Install the nut and tighten to a torque to 5 to 8 Nm (4
to 6 lb. ft.).
Section 21 - Transmission, Drivelines - Chapter 7
57-10
57-6
57-5
21-7-20
Installation
STEP 31
1
3
Install the inching valve and range transmission
control valve as follows:
1. Install a new inching valve gasket on top of the
range transmission. Install the inching valve and
four retaining bolts. Tighten the bolts to a torque
of 50 to 60 Nm (37 to 44 lb. ft.).
2. Install a new gasket on top of the inching valve
and install the range transmission control valve.
Install the M8 socket head bolts(3) and tighten to
a torque of 27 to 32 Nm (20 to 24 lb. ft.).
3. Connect the Hydraulic tubes to the inching valve.
4. Connect the wire harness to the inching valve
solenoid.
5. Connect the wire harness to the range valve
solenoids (2).
6. Connect the regulated supply tube (1) to the
range valve.
STEP 32
Install or lower the cab as shown in in the Cab Raise/
Removal and Installation Section of this Repair
Manual.
2
RD02E274