New Holland T8010 Manual page 308

STEP 216
Install a separator plate. Continue until the six friction
and six separator plates are installed.
STEP 217
Install the piston.
Section 21 - Transmission, Drivelines - Chapter 6
Rd04K066
RD05K036
21-6-55
STEP 218
Measure the distance between the top of the hub (1)
and the top of the piston (2).
If dimension is greater than 29.0 MM, use one spring
spacer.
If dimension is greater than 30.5 MM use two spring
spacers.
If dimension is less than 29.0 MM, DO NOT use
spring spacer.
Remove piston, spacers, friction plates and backing
plate from the hub.
NOTE: If spring spacer is needed it will be placed
between the Belleville springs and the retainer ring
during assembly.
STEP 219
A
From a length of 4 inch ID, 1/4 inch wall PVC pipe,
cut a piece 5 inches long (A).
IMPORTANT: When cutting the pipe, make sure
each end is cut square.
1
2
Rd05K059
RD05K086