New Holland T8010 Manual page 469

STEP 5
Push the DECR key until the display reads Fsus
Manual. Press the PROG key.
STEP 6
The display should read POS nnnnn mV, where
nnnnn is the millivolt reading of the position sensor.
The Front Suspension upper and lower lockout
valves are now both energized to the ON position.
W h e n P O S n nn n n m V i s d i s p l aye d t he f r o n t
suspension momentary rocker switch is disabled.
This display is for monitoring the front suspension
position sensor.
Section 25 - Four-Wheel Drive Front Axle - Chapter 5
RD06A030
RD06A026
25-5-14
STEP 7
Next use the DECR key until the display reads Raise
nnnnn mV. The nnnnn reading is the millivolt reading
for the position sensor output.
Press an hold down the front suspension momentary
rocker switch to energize the front suspension raise
solenoid. Release the rocker switch to turn off.
Press the DECR key.
STEP 8
The display will read Lower nnnnn mV. The nnnnn
reading is the millivolt reading for the position sensor
output.
Press an hold down the front suspension momentary
rocker switch to energize the front suspension lower
solenoid. Release the rocker switch to turn off.
Press the DECR key.
RD06A031
RD06A032