New Holland T8010 Manual page 219

Hide thumbs Also See for T8010:

Table of Contents

Install 1st-2nd speed driven gear as follows:

1. Install a new seal ring on the (1st-2nd speed)

driven gear.

2. Align the friction plate teeth. Install the gear into

the clutch pack. The splined hub of the gear

must be facing down.

3. Slight oscillation of the gear will help with the

installation. The splined hub of the gear must

engage all the friction plates.

Install a caged needle bearing into the gear hub.

Section 21 - Transmission, Drivelines - Chapter 4

Install the two bearing thrust washers and the needle

thrust bearing. The needle thrust bearing must be

between the two bearing thrust washers.

Install the bearing on the shaft with larger OD side of

the bearing cone facing down. Press the bearing on

the inner race to properly seat the bearing on the

Chapters

Table of Contents

T8020 T8030 T8040