New Holland T8010 Manual page 451

Hide thumbs Also See for T8010:

Table of Contents

NOTE: Tractor with suspended axle shown. All drive

shafts are similar.

Park the tractor on a hard, level surface. Put the

transmission shift lever in PARK. Turn off the engine

and remove the key. Place blocks in front of and

behind the rear wheels.

Mark the position of the sleeve on the drive shaft

cover (1). Remove the plastic pin (2). Slide the cover

toward the transmission.

Section 25 - Four-Wheel Drive Front Axle - Chapter 4

FWD DRIVE SHAFT

Remove the suspended front axle hoses (1), if

equipped. Remove the steering hoses (2) (right side

shown) from the drive shaft cover.

Mark the drive shaft to pinion yoke (1). Support the

drive shaft. Remove the four drive shaft to pinion

yoke retaining bolts (2).

Slide the drive shaft protector from the drive shaft.

Chapters

Table of Contents

T8020 T8030 T8040