New Holland T8010 Manual page 612

Hide thumbs Also See for T8010:

Table of Contents

Position Sensor Adjustment

The angle position sensor must be checked at the

fully collapsed and fully extended positions. Adjust

the sensor as follows:

1. Apply 10 to 30 volts DC to pin 2.

2. Measure the signal current at pin 3. (4 to 20 mA)

3. Adjust the sensor slots to achieve 4 to 6 mA

when axle is compressed and 18 to 20 mA when

the axle is extended.

When adjustment is complete, tighten the sensor

screws to a torque of 4 to 4.5 Nm (36 to 40 lb. in.).

NOTE: The axle must be calibrated after installing

onto the tractor. See calibration information in the

Suspension FWD Axle How it Works Section of this

Repair Manual.

Section 25 - Four-Wheel Drive Front Axle - Chapter 11

Chapters

Table of Contents

T8020 T8030 T8040