New Holland T8010 Manual page 940

STEP 48
Install the EDC components (refer to exploded view
for Step 4) as follows:
1. Move a lower draft arm into position for installation.
If necessary, refer to the view in Step 10.
2. Install the cover, EDC pin, and tube subassembly
in place to secure the draft arm
NOTE: Refer to EDC Pin Assembly for application of
antisieze and silicon. Remove all original silicon
before applying new silicon.
3. Install the three bolts to hold the cover in place.
4. Install the shoulder bolt in the upper forward
hole.
5. Install the bolt to secure the tube. Tighten to a
torque of 17 to 31 Nm (13 to 23 lb. ft.).
6. Tighten to a torque of 62 to 80 Nm (57 to 73 lb. ft.).
NOTE: For details on assembly of the EDC pin, refer
to EDC Pin Assembly in this section.
Section 35 - Hydraulic Systems, 3PT - Chapter 11
27-5
35-11-19
STEP 49
Check hitch operation as follows:
1. Turn on the ignition key.
2. Operate the hitch slowly for one cycle.
3. If there are not visible problems, operate the
hitch for several cycles and check for binding or
malfunction.
4. Attach top link.
5. Install quick coupler
6. Calibrate hitch. (refer to Hitch Controller Section
in this Service Manual.)
26-16