STEP 22
Once all Belleville washers are removed, remove the
third retaining ring.
STEP 23
Remove the thrust washers (1) and thrust bearing (2).
STEP 24
Lift the hub off the shaft, taking care not to damage
the bearings.
STEP 25
Place Special Tool 380002454 (1) over the hub so
that the feet of the tool are sitting on the three brake
adjuster pins. Compress the three brake adjuster
pins until they are flush with the brake pusher plate
(2). Reset the tool so that the gap in the snap ring (3)
is centered in the opening of the tool (1). Compress
the brake pusher plates (2) just enough to relieve the
pressure on the snap ring.
Section 31 - PTO - Chapter 2
1
1
31-2-10
3
1
3
RD05N142
2
RD05N145
RD05B032
2
RD05D015