New Holland T8010 Manual page 384

Hide thumbs Also See for T8010:

Table of Contents

Insert the top cylinder pin as follows:

1. Pin must be clean and free of oil, grease, anti-

2. Adjust the vertical position of the rockshaft, if

necessary to align holes in cylinder rod and

3. Insert the top cylinder pin through the holes

(groove to inside).

Install the locking flag plate. Install the bolt and

tighten to a torque of 82 to 106 Nm (60 to 70 lb. ft.).

Section 21 - Transmission, Drivelines - Chapter 8

Connect the hydraulic lines to the top and bottom of

the hitch cylinder. Repeat for the other hitch lift

Install the vertical lift links as follows:

1. Pin must be clean and free of oil, grease, anti-

2. Refer to the view in Step 10 if necessary to

a s s e m bl e t h e ve r t i c a l l i f t l i n k fo r p r o p e r

orientation of swivels and flags.

3. Place a hitch swivel pin (groove to outside) part-

way through the outside hole in the rockshaft

4. Lift the link into position by aligning the swivel pin

with the hole in the swivel.

5. Push the swivel pin through the lift link into the

inner ear of the rockshaft arm.

Chapters

Table of Contents

T8020 T8030 T8040