New Holland T8010 Manual page 643

Hide thumbs Also See for T8010:

Table of Contents

Put the planetary in place on the inner axle shaft

(three planetary gears shown).

Install the planetary assembly retaining ring in the

groove on the axle shaft.

1. NYLON WEAR INSERT

Install a new nylon wear insert in the axle.

Section 27 - Rear Axle - Chapter 1

Fill the inner two grooves of the axle seal approximately

half full with 251H EP Lithium grease (1).

4-1/2 Inch Axle

Chapters

Table of Contents

T8020 T8030 T8040