STEP 14
2
1
Remove the har nes s cla mp ( 1) . Remove th e
compressor clutch harness (2) from the clamp.
Reinstall the mounting bolt. Remove the ground wire
(3) and reinstall the mounting bolt.
STEP 15
Remove the high (1) and low (2) pressure A/C line.
Discard the O-rings. Cap all fittings.
STEP 16
Remove the air cleaner restriction switch harness.
Section 10 - Engine - Chapter 1
3
RD05N108
2
1
RD05N109
RD05N110
10-1-5
STEP 17
2
1
Disconnect the coolant fill tube (1) at the deaeration
tank hose (2) and the engine block (3). Remove the
tube.
STEP 18
Loosen the air cleaner to turbo inlet hose clamp.
STEP 19
Disconnect the alternator wire harness connector.
This connector is located on the left side near the
hood support.
3
RD05N136
RD05N111
RD05N117