Avaya S8700 Maintenance Manual page 668

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance Commands

repeat number

Error Messages

If the command entered is in conflict with another currently executing command,

then a message will be displayed showing the login id of the conflicting user and

the conflicting command. The message is as follows:

'login id':'command' has a command conflict

If during the execution of a command a resource problem occurs that requires the

user to restart the command, then the following message will be displayed:

Command resources busy;

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the

following message will be displayed:

All maintenance resources busy; try again later

Issue 1 May 2002

This will execute a more comprehensive and longer version of the

diagnostic tests. This may involve both destructive and nondestructive

The "number" specifies how many times each test in the sequence is to be

repeated. "Number" may be any integer between 1 and 100.

This option causes the test sequence (short or long) to repeat until the

alarm is cleared or a single test in the sequence fails. The long clear option

forces a clear of all alarms if no errors are encountered during testing. The

short clear option only clears alarms pertinent to tests in the short

Executing a clear with short option, may not clear all alarms

even if all tests pass.

Since the "clear long" options clear all counters if tests pass, it

is possible for firmware counters to be cleared even when a

problem exists. In some cases customer service might

degrade since calls may be routed over defective equipment.

Troubleshooting