Igmp-Snooping Max-Response-Time - H3C S5120-SI Series Command Reference Manual

View
VLAN view
Default Level
2: System level
Parameters
ip-address: Specifies a source address for the IGMP leave messages sent by the IGMP Snooping proxy,
which can be any legal IP address.
current-interface: Specifies the IP address of the current VLAN interface as the source address of
IGMP leave messages sent by the IGMP Snooping proxy. If no IP address has been assigned to the
current VLAN interface, the default IP address 0.0.0.0 is used.
Description
Use the igmp-snooping leave source-ip command to configure the source IP address of the IGMP
leave messages sent by the IGMP Snooping proxy.
Use the undo igmp-snooping leave source-ip command to restore the default.
By default, the source IP address of the IGMP leave messages sent by the IGMP Snooping proxy is
0.0.0.0.
Note that:
Before configuring this command in a VLAN, enable IGMP Snooping in the VLAN.
The source IP address configured in the igmp-snooping leave source-ip command also applies
when the simulated host sends IGMP leave messages.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP Snooping in VLAN 2 and configure the source IP address of IGMP leave messages sent
by the IGMP Snooping proxy in VLAN 2 to 10.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping leave source-ip 10.1.1.1

igmp-snooping max-response-time

Syntax
igmp-snooping max-response-time interval
undo igmp-snooping max-response-time
1-16