Igmp-Snooping Last-Member-Query-Interval; Igmp-Snooping Leave Source - H3C S5120-SI Series Command Reference Manual

[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-Gigabitethernet1/0/1] igmp-snooping host-join 232.1.1.1 source-ip 1.1.1.1 vlan 2

igmp-snooping last-member-query-interval

Syntax
igmp-snooping last-member-query-interval interval
undo igmp-snooping last-member-query-interval
View
VLAN view
Default Level
2: System level
Parameters
interval: Interval between IGMP last-member queries, in seconds. The effective range is 1 to 5.
Description
Use the igmp-snooping last-member-query-interval command to configure the interval between
IGMP last-member queries in the VLAN.
Use the undo igmp-snooping last-member-query-interval command to restore the default setting.
By default, the IGMP last-member query interval is 1 second.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable, last-member-query-interval.
Examples
# Enable IGMP snooping and set the interval between IGMP last-member queries to 3 seconds in VLAN
2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping last-member-query-interval 3
igmp-snooping leave source-ip
Syntax
igmp-snooping leave source-ip { ip-address | current-interface }
undo igmp-snooping leave source-ip
1-15