Table of Contents
Advertisement
Default level
2: System level
Parameters
number: Maximum number of selected member interfaces. The value range for this argument is 1 to 8.
Description
Use the bundle max-active links command to limit the number of selected interfaces in an HDLC link
bundle.
Use the undo bundle max-active links command to remove the limit.
By default, no limit is set on the maximum number of selected member interfaces in an HDLC link bundle.
The value specified using this command cannot be smaller than that specified using the bundle
min-active links command.
Use the bundle max-active links command together with the bundle member-priority command to make
sure that the peer interfaces of a link always have the same selected status. If one end is selected but the
other end is unselected, communication failure will occur.
Related commands: bundle min-active links and bundle member-priority.
Examples
# Limit the number of selected member interfaces in HDLC link bundle 1 to 8.
<Sysname> system-view
[Sysname] interface Hdlc-bundle 1
[Sysname-Hdlc-bundle1] bundle max-active links 8
bundle member-priority
Syntax
bundle member-priority priority
undo bundle member-priority
View
POS interface view
Default level
2: System level
Parameters
priority: Bundling priority of an HDLC link bundle member interface. The value range for this argument
is 1 to 65535.
Description
Use the bundle member-priority command to set the bundling priority of an HDLC-enabled POS
interface.
Use the undo bundle member-priority command to restore the default.
The default bundling priority of an HDLC-enabled POS interface is 32768.
A higher priory value equals a lower bundling priority.
52
Advertisement
Table of Contents
