Display Link-Aggregation Verbose - H3C s3600 series Command Manual

--------------------------------------------------------------------------
1 S 0x8000,0000-0000-0000 0
2 M none
Table 1-2 Description on the fields of the display link-aggregation summary command
Aggregation Group Type
Loadsharing Type
Actor ID
AL ID
AL Type
Partner ID
Select Ports
Unselect Ports
Share Type
Master Port

display link-aggregation verbose

Syntax
display link-aggregation verbose [ agg-id ]
View
Any view
Parameters
agg-id: Aggregation group ID, which ranges from 1 to 416 and must be the ID of an existing aggregation
group.
Description
Use the display link-aggregation verbose command to display the details about a specified
aggregation group or all aggregation groups.
Note that as ports in a manual link aggregation groups do not acquire the information about their peers
automatically, so the entries in the information about the peer ports displayed are all 0 instead of the
actual values.
0
Field
1 NonS Ethernet1/0/2
1 NonS Ethernet1/0/3
Description
Aggregation group type: D for dynamic, S for static, and
M for manual
Load sharing type: Shar for load sharing and NonS for
non-load sharing
Local device ID
Aggregation group ID
Aggregation group type: D (dynamic), S (static), or M
(manual)
ID of the remote device, including the system priority and
system MAC address of the remote device
For a device belonging to an dynamic aggregation group
or static aggregation group, if no LACP packet is
received, the partner ID is displayed as 0x8000,
0000-0000-0000.
Number of the selected ports
Number of the unselected ports
Load sharing type: Shar (load-sharing), or NonS
(non-load-sharing)
the smallest port number in an aggregation group
1-3