Display Link-Aggregation Verbose - H3C S5120-SI Series Command Reference Manual

Share Type

display link-aggregation verbose

Syntax
display link-aggregation verbose [ bridge-aggregation [ interface-number ] ]
View
Any view
Default Level
1: Monitor level
Parameters
bridge-aggregation: Displays detailed information about the Layer 2 aggregate groups corresponding
to Layer 2 aggregate interfaces.
interface-number: Aggregate interface number. Note that the aggregate interface you specify must
already exist.
Description
Use the display link-aggregation verbose command to display detailed information about the
aggregation groups corresponding to the aggregate interfaces.
Note that:
To display the information of a specific Layer 2 aggregate group, use the display link-aggregation
verbose bridge-aggregation interface-number command.
To display the information of all Layer 2 aggregate groups, use the display link-aggregation
verbose bridge-aggregation command.
To display the information of all aggregate groups, use the display link-aggregation verbose
command.
The bridge-aggregation keyword becomes available only after you create Layer 2 aggregate
interfaces on the device.
Examples
# Display the detailed information of the aggregation group corresponding to Layer 2 aggregate
interface Bridge-Aggregation 10.
<Sysname> display link-aggregation verbose bridge-aggregation 10
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected,
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregation Interface: Bridge-Aggregation10
Field
Load sharing type
U -- Unselected
Description
1-6