Ipv6 Router Rip - Allied Telesis x310-26FT Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
6
IPV ROUTER RIP

ipv6 router rip

Overview Use this command to enable RIPng routing on an interface.
Use the no variant of this command to disable RIPng routing on an interface.
Syntax ipv6 router rip
no ipv6 router rip
Default RIPng routing is disabled by default.
Mode Interface Configuration for a VLAN interface only.
Usage This command can only be configured on VLAN interfaces.
Examples To enable RIPng routing on the VLAN interface vlan2, enter the below commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config)#
awplus(config-if)#
To disable RIPng routing on the VLAN interface vlan2, enter the below commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
configure terminal
router ipv6 rip
exit
interface vlan2
ipv6 router rip
configure terminal
interface vlan2
no ipv6 router rip
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
845