VLAN Stacking Commands
ethernet-service sap sap-profile
Associates a VLAN Stacking Service Access Point (SAP) with a SAP profile. This command is also used
to change an existing SAP profile association.
ethernet-service sap sap_id sap-profile sap_profile_name
no ethernet-service sap sap_id
Syntax Definitions
sap_id
sap_profile_name
Defaults
The "default-sap-profile" profile is automatically associated with the SAP ID when the SAP is created.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command along with the SAP ID to remove the SAP profile.
•
If a profile association already exists for the specified SAP ID, the current profile is replaced with the
profile specified with this command.
•
To change the profile associated with the SAP back to the default profile, enter "default-sap-profile"
with this command.
•
Do not specify a service name; doing so returns an error message. This command is only for
associating an existing profile to a VLAN Stacking SAP.
Examples
-> ethernet-service sap 10 sap-profile CustomerC
-> ethernet-service sap 11 sap-profile CustomerD
-> ethernet-service sap 11 sap-profile default-sap-profile
Release History
Release 7.1.1; command introduced.
OmniSwitch CLI Reference Guide
The SAP ID number.
The name of the SAP profile to associate with this SAP ID.
March 2011
ethernet-service sap sap-profile
page 34-21