Table of Contents
Advertisement
Examples
# Set the minimum MP packet size for fragmentation to 500 bytes.
<Sysname> system-view
[Sysname] interface Mp-group4/1/28
[Sysname-Mp-group4/1/28] ppp mp min-fragment 500
ppp mp mp-group
Syntax
ppp mp mp-group mp-number
undo ppp mp
View
Synchronous serial interface view
Default level
2: System level
Parameters
mp-number: MP-group interface number.
Description
Use the ppp mp mp-group command to add the current interface to an MP-group and enable the
interface to operate in MP mode.
Use the undo ppp mp mp-group command to remove the current interface from the specified MP-group
it belongs to.
This command should be used along with the interface mp-group command. However, the order in
which the two commands are executed can be either one. That is, you can create an MP-group interface
and then add an interface to the MP-group; or add the interface to the MP-group and then create the
MP-group.
NOTE:
•
Only physical interfaces can be added to an MP group. Logical interfaces (such as Tunnel interfaces) do
not support the ppp mp mp-group command.
The number of timeslots assigned to each bundled serial interface must be the same. Otherwise, the
•
serial interfaces cannot join the MP group and their states transition between up and down repeatedly.
Before deleting an MP bundle, you must first remove all the serial interfaces from the MP group, that is,
•
bring the MP group down. Otherwise, the MP-group interface cannot be removed.
Examples
# Add interface Serial 4/1/9/1:0 to MP-group 4/1/28.
<Sysname> system-view
[Sysname] interface Serial 4/1/9/1:0
[Sysname-Serial4/1/9/1:0] ppp mp Mp-group 4/1/28
46
Advertisement
Table of Contents
