Lldp Notification Remote-Change Enable; Lldp Timer Notification-Interval - H3C MSR Series Command Reference Manual

Usage guidelines
An LLDPDU carries only one management address TLV. If you set the management address
multiple times, the most recent configuration takes effect.
In Layer 2 Ethernet interface view, if you run the lldp management-address-tlv command without
specifying the ip-address argument, the advertised management address is the main IP address of
the lowest-ID VLAN carried on the interface. If none of the carried VLANs is assigned an IP address,
no management address will be advertised.
In Layer 3 Ethernet interface view, if you run the lldp management-address-tlv command without
specifying the ip-address argument, the advertised management address is the IP address of the
Layer 3 Ethernet port. If no IP address is configured for the port, no management address will be
advertised.
Examples
# Set the management address to 192.6.0.1 for Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] lldp management-address-tlv 192.6.0.1

lldp notification remote-change enable

Use lldp notification remote-change enable to enable LLDP trapping for a port or all ports in a port
group.
Use undo lldp notification remote-change enable to disable LLDP trapping.
Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
Default
LLDP trapping is disabled on ports.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Examples
# Enable LLDP trapping for Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] lldp notification remote-change enable

lldp timer notification-interval

Use lldp timer notification-interval to set the LLDP trap transmit interval.
Use undo lldp timer notification-interval to restore the default.
Syntax
lldp timer notification-interval interval
undo lldp timer notification-interval
145