Gvrp Registration - H3C MSR Series Command Reference Manual

Default
GVRP is disabled.
Views
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default command level
2: System level
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
MSR 20
MSR 30
MSR 50
MSR 2600
MSR3600-51F
Settings in system view take effect globally. Settings in Ethernet view or Layer 2 aggregate interface
take effect on the current interface. Settings in port group view take effect on all ports in the port
group.
To enable GVRP on a port, enable GVRP globally before you enable it on the port.
In interface view, you can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
Examples
# Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.
Related commands
display gvrp status

gvrp registration

Use gvrp registration to configure the GVRP registration mode.
Use undo gvrp registration to restore the default.
Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
Command compatibility
No
No
No
No
No
No
Yes
Yes
Yes
Yes
125