Stp No-Agreement-Check - H3C S5120-SI Series Command Reference Manual

Use the undo stp mode command to restore the MSTP work mode to the default setting.
By default, an MSTP-enabled device works in MSTP mode.
Related commands: stp mcheck, stp enable.
Examples
# Configure the MSTP-enabled device to work in STP-compatible mode.
<Sysname> system-view
[Sysname] stp mode stp

stp no-agreement-check

Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Layer 2 Ethernet port view, port group view, Layer 2 aggregate port view
Default Level
2: System level
Parameters
None
Description
Use the stp no-agreement-check command to enable No Agreement Check on the port(s).
Use the undo stp no-agreement-check command to disable No Agreement Check on the port(s).
By default, No Agreement Check is disabled.
Note that:
Configured in Layer 2 Ethernet port view, the setting takes effect on the current port only;
configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate port view, the setting takes effect only on the aggregate port;
configured on a member port in an aggregation group, the setting can take effect only after the port
leaves the aggregation group.
This feature takes effect only after you enable it on the root port.
Examples
# Enable No Agreement Check on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp no-agreement-check
1-27