ADTRAN AOS Version R10.1.0 Command Reference Manual page 2303

Command Reference Guide
spanning-tree edgeport
Use the spanning-tree edgeport command to set this interface to be an edgeport. This command overrides
the global setting (refer to
command to return to the default value.
Syntax Description
No subcommands.
Default Values
By default, this command is set to disable.
Command History
Release 5.1
Release 8.1
Functional Notes
When an interface is designated as an edgeport, the interface will immediately go to a forwarding state
when the link becomes active. When an interface is not designated as an edgeport, the interface must go
through the listening and learning states before going to the forwarding state.
Usage Examples
The following example configures the interface to be an edgeport:
(config)#interface frame-relay 1.16
(config-fr 1.16)#spanning-tree edgeport
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface frame-relay 1.16
(config-fr 1.16)#spanning-tree edgeport disable
or
(config)#interface frame-relay 1.16
(config-fr 1.16)#no spanning-tree edgeport
60000CRG0-35E
spanning-tree edgeport default on page
Command was introduced.
Command was added to the ATM Subinterface command set.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
1345). Use the no form of this
2303