ADTRAN AOS Version R10.1.0 Command Reference Manual page 2312

Command Reference Guide
bridge-group <value>
Use the bridge-group command to assign an interface to the specified bridge group. Use the no form of
this command to remove the interface from the bridge group.
Syntax Description
<value>
Default Values
By default, there are no configured bridge groups.
Command History
Release 9.1
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay subinterface, etc.).
Usage Examples
The following example assigns the high level data link control (HDLC) interface labeled 1 to bridge group 1:
(config)#interface hdlc 1
(config-hdlc 1)#bridge-group 1
60000CRG0-35E
Specifies the bridge group (by number) to which to assign this interface.
Range is 1 to 255.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
HDLC Interface Command Set
2312