ADTRAN AOS Version R10.1.0 Command Reference Manual page 2301

Command Reference Guide
spanning-tree bpdufilter
Use the spanning-tree bpdufilter command to block bridge protocol data units (BPDUs) from being
transmitted and received on this interface. To return to the default value, use the no form of this command.
Variations of this command include:
spanning-tree bpdufilter disable
spanning-tree bpdufilter enable
Syntax Description
disable
enable
Default Values
By default, this command is set to disable.
Command History
Release 5.1
Functional Notes
The purpose of this command is to remove a port from participation in the spanning tree. This might be
beneficial while debugging a network setup. It normally should not be used in a live network.
Usage Examples
The following example enables the BPDU filter on the interface:
(config)#interface frame-relay 1.16
(config-fr 1.16)#spanning-tree bpdufilter enable
60000CRG0-35E
Disables the BPDU filter.
Enables the BPDU filter.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
2301